If your WAN provider does the same thing, then the steps here should work for you.I admit the MT brand of ROS has had its fair shares of big issues.

StarHub uses DHCPv6 for address and prefix allocation.

This is the setup that works for me on StarHub fibre broadband network. On a Linux box, the following commands will show that: Your LAN clients should now receive a global IPv6 address, and have a default IPv6 route to your MikroTik LAN interface. Managed Address Configuration: Uncheck.RA Lifetime: Set a reasonable time, like 1800 seconds.The final step involves configuring Route Advertisements. From Pool: Use the pool name you had created earlier.Go to IPv6, Addresses, and click on Add New. In my case, I will use bridge1 as my primary LAN. Next, you’ll need a global IPv6 address configured on your LAN interface. Wait a few moments, and check that your router should now receive an IPv6 address as well as a IPv6 delegated prefix.

Pool Prefix Length: 64 is usually correct.Ĭlick OK.

Pool Name: Give it a unique name, which you’ll need to use later.

Setup the new DHCP client entry as follows: The next step is to configure the MikroTik router to use a DHCPv6 client to receive an IPv6 prefix delegation from the ISP. You should see an entry for IPv6 on the left navigation menu now. Go to System, Packages, then click on the IPv6 entry in the table, click enable, Close, then reboot. It’s likely that you’ll find this disabled by default out of the box. The first thing to do is to make sure that you have the IPv6 package enabled. Hence, this tutorial may also be useful to other broadband networks. The instructions in this mini tutorial is reasonably generic, as my broadband provider, StarHub, doesn’t do anything weird on their network. MikroTik doesn’t quite have a UI that is consumer friendly, so it’s not anything like you’d expect from a consumer router like D-Link or Linksys, and not even anything like pfSense. In that setup, the MIkroTik didn’t actually need any IPv6 configuration of its own. I am not unfamiliar with MikroTik, but my previous MikroTik hAP ac was used primarily as a wired and wireless bridging device behind my pfSense gateway. So when I recently got a new MikroTik router to replace my pfSense gateway, one of the tasks I had to do was to configure IPv6 on it. I use IPv6 everywhere I can, not just on my websites, but also on my home broadband.

Ipv6 firewall mikrotik